Noisebug
Return to the NoiseBug home page Have you put any NoiseBug goodies in your shopping cart? NoiseBug Ordering Information NoiseBug Used Gear & Specials! Virtually tour our Pomona Store! Got questions? NoiseBug has answers! Search the NoiseBug site for the product of your choice

 
Synthesis Technology/MOTM e580 Resampling Mini-Delay
Synthesis Technology/MOTM e580 Resampling Mini-Delay

NoiseBug Price : $339.99

Yes, the Synthesis Technology/MOTM e580 Resampling Mini-Delay is in stock!

Related Items:
http://synthtech.com/docs/E580_manual.pdf

Manufacturer Description:
a new spin on an old friend.

the synthesis technology e580 resampling mini-delay emulates the classic sounds of digital, bbd and tape-based delays with 4 parameters under voltage control. the 14hp wide euro module accepts either +-12v euro standard power or +-15v motm/frac power. using a 40mhz dsp and 24-bit codec, the e580 recreates the pitch-shift modulating of bbds with the variable bandwidth and noise floor without costly bbd ics. in tape mode, wow& flutter, tape saturation and non-linear distortion model classic tape units without the bulk and maintenance. there are 2 simultaneous audio outputs: a straight delay and a variable tapped delay. the tap position is a percentage of the main delay time. this allows very short delays (<350us) as well as long delays (750ms). both tap position (‘offset’) and main delay time are voltage-controlled over a -5v to +5v range.

feedback is jumper-selectable from either the tapped position or the main delay. this flexibility can generate standard ‘rhythmic’ delays (feedback from main delay) or a series of 'pre-delay reflections' (tapped delay) which sound very different from each other.

SPECS
Height 3U (128.5mm)
Width 14hp (70.8mm)
Depth 32mm
Power 14-pin Eurorack (90mA from +12V, 20mA from -12V)
4-pin MOTM (90mA from +15V, 20mA from -15V)

CV input range
10Vpp (-5V to +5V), DC to 8KHz

Audio Input
10Vpp (-5V to +5V), 18KHz bandwidth (in Clean mode)

Audio Output
10Vpp (-5V to +5V), 5Hz to 18KHz

Delay Time
Maximum of 780ms (0.78 seconds)

Jumper Options
JP2: feedback will be taken from the Tap output (position 1-2) or the Delay output (position 2-3)

PANEL CONTROLS
Wet/Dry Sets the effects mix

Feedback Applies negative feedback (CCW) or positive feedback (CW). When placed in the center, there is zero feedback.

Tap Offset Sets the percentage of the Tap Out in relation to the Delay Time. For example, if the Delay Time is set to 100ms, the Tap is set from 0-100ms. The time resolution is very fine (over 7,000 independent positions) to allows very smooth modulation of the Tap position.

Delay Time Sets the delay time for the Delay Out. Note that since Tap Out is a percentage of Delay Time, if you change the Delay Time there is a corresponding change to the Tap Out delay time. The time ratio of Delay to Tap is constant however.

Mode switch Choose from one of three delay types

INPUTS AND OUTPUTS
Audio In Signal input, can be line level or modular synth level
Delay Out Delayed signal output
Tap Out Delayed output modified by Tap Offset value
Delay input CV input for modulating the Delay Time value
Mix input CV input for modulating the Wet/Dry value
Feedback input CV input for modulating the Feedback value
Offset input CV input for modulating the Tap Offset value
Your destination for Large Format Modular and Hardware Synthesizers in the USA